SystemView

How to run the SystemView app:

1. Start the SystemView app.
2. If the “Recorder Configuration” has not been set-up:
   • Open the Recorder Configuration window by clicking on: Target | “Recorder Configuration” | J-Link.
   • Set-up the Recorder Configuration window as shown in Figure A.1:

Figure A.1: SystemView’s Recorder Configuration

3. Ensure the target program is running on the dev-board, e.g., via Ozone.
4. To avoid overflow with SystemView Recorder, stop the Ozone debug-session, if it is running. This can be done in Ozone by clicking on the red on/off icon, or by clicking on Debug | “Stop Debug Session”.
5. When SystemView Recorder can be run:
   • After the target-program runs SEGGER_SYSVIEW_Conf().
   • If FreeRTOS is being used, after the target-program runs vTaskStartScheduler().
6. To run the SystemView Recorder:
   ...